Dodge 3.6 Coolant Temp Sensor Location. Looking from the front of the motor, the coolant temp sensor is just to the left of the thermostat housing in the intake manifold. Temporarily support compressor to gain access to ect sensor (3).
Engine Coolant Temperature Sensor Location ? | Dodge Durango Forum from www.dodgedurango.net
The temp gauge in my 2014 durango 3.6 liter goes up and down , i replaced thermostat , water pump , oil cooler , as well as overflow tank and a radiator flush. Go to auto zone they can help.youll have to drain some. I need to know the signal wire color and location for the water temp.
Looking From The Front Of The Motor, The Coolant Temp Sensor Is Just To The Left Of The Thermostat Housing In The Intake Manifold.
4 people found this helpful. Drain and recycle the engine coolant. Its in between 1/4 and 3/8'' socket driver.so about 5/16 or 7/16ths.
Disconnect The Engine Coolant Temperature (Ect).
2008 durango limited 4x2 hemi with every. Yeah i thought of that but mine is really stuck.lol! 2014 jeep grand cherokee overland (jeepronibo);
Need To Know The Location Of Coolant Temp Sensor It Should Be Right By The Upper Radiator Hose.
3.6l engine coolant temp sensor removal.pdf. When standing in front of engine, it is on the right side very low on back side of engine block. Disconnect electrical connector (2) from sensor (3).
Remove The Intake Manifold Cover, If Necessary.
Remove sensor (3) from cylinder block. Can not locate ect sensor on 2014 dodge durango 3.6 engine, changed thermostat still overheating. Coolant temperature sensor location for 1999 dodge durango.
The Sensor Is Right Next To The Heater Hose Outlet On The Front Passenger Side Of Intake Manifold.
Literally right behind the thermostat housing in the temperature sensor, it screws into the back of that housing. Nice and hard to get to. Discussion starter · #6 · may 16, 2007.
